調整零位電壓。單擊此按鈕時，一個實用程序?qū)?dòng)

幫助您設置直接零位電壓。由于此實用程序提供活動

來自3500機架的反饋，需要與機架連接。提到

第5.2節（調整比例因子和零點位置）。

傳感器

以下傳感器類型可用于推力位置通道（非支架輸入/輸出模塊）：

3300-5mm前置器

3300-8mm前置器

7200-5mm前置器

7200-8mm前置器

7200-11mm前置器

7200-14mm前置器

3000（-18V）前置器

3000（-24V）前置器

3300 RAM前置器

3300-16毫米HTPS

非標準

以下傳感器類型可用于推力位置通道

（安全柵輸入/輸出模塊）：

3300-5mm前置器

3300-8mm前置器

7200-5mm前置器

7200-8mm前置器

3300 RAM前置器

非標準

“自定義”按鈕

用于調整傳感器的比例因子。如果非標準選擇為

傳感器類型，OK Limits（正常限值）也可以調整。非標準

換能器的比例因子必須在85和230 mV/mil之間。此外，必須

在OK（正常）上限和下限之間至少為2伏。

Adjust the Zero Position voltage. When this button is clicked a utility starts that

helps you set the direct zero position voltage. Since this utility provides active

feedback from the 3500 rack, a connection with the rack is required. Refer to

Section 5.2 (Adjusting the Scale Factor and the Zero Position).

Transducer

The following transducer types are available for the Thrust Position Channel (nonbarrier I/O module):

3300 - 5mm Proximitor

3300 - 8mm Proximitor

7200 - 5mm Proximitor

7200 - 8mm Proximitor

7200 - 11mm Proximitor

7200 - 14mm Proximitor

3000 (-18V) Proximitor

3000 (-24V) Proximitor

3300 RAM Proximitor

3300 - 16mm HTPS

Nonstandard

The following transducer types are available for the Thrust Position Channel

(barrier I/O module):

3300 - 5mm Proximitor

3300 - 8mm Proximitor

7200 - 5mm Proximitor

7200 - 8mm Proximitor

3300 RAM Proximitor

Nonstandard

Customize button

Used to adjust the Scale Factor for transducers. If Non-standard is selected as

the transducer type, the OK Limits can also be adjusted. The Non-standard

transducer's scale factor must be between 85 and 230 mV/mil. Also, there must

be at least 2 volts between the Upper and Lower OK Limits.?